Mevo Start: How Do I Charge/Power My Camera

If you've just unboxed your new Mevo Start camera (Congratulations!) then the very first thing you're probably thinking about is how to get it charged up and ready to use.

All you need to do is take the USB-C to USB-A cable included in the box and plug the USB-C end into the back of the Start (as shown below) and then plug the USB-A end into either a USB charger or into your computer. (USB chargers are recommended and will typically be a faster charge than a computer)

Start_Back_Angle_copy.pngusbc_cable.png

You'll be able to tell the status of how full the battery is by the white battery indicator lights on the back of the camera above the power button. When your camera is fully charged it will show four white lights.

Note: If you are using your camera as a Wired Webcam don't worry it will sustain the charge while you use it but may not increase in charge depending on the ports power limits.

 

Was this article helpful?
4 out of 4 found this helpful
Have more questions? Submit a request

Comments

0 comments

Article is closed for comments.