Can Mevo or Boost Output via HDMI, or SDI?

No, unfortunately, the Mevo and Boost do not have a direct video output (e.g. for projectors, monitors, etc.)

Mevo does not have an HDMI or SDI port, it can however output via USB to a computer to be used as a webcam. This allows you to use it with third party software including but not limited to Livestream Studio, Open Broadcaster Software (OBS), VMix, Ecamm and Wirecast.

Troubleshooting Steps

Can I use an adapter to the Mevo that has an HDMI port?
The Mevo will not send a video signal to any third party adapters that include an HDMI port so this would not work as a video out solution.
Still having an issue?
Please open a support ticket here so a Mevo Customer Experience Agent can address this for you.
Open Ticket
Was this article helpful?
0 out of 0 found this helpful
Have more questions? Submit a request

Comments

5 comments
  • yes!

    MEVO start can be hdmi output if you add 'uvc webcam to hdmi  adapter"

    MEVO start hdmi output connect ATEM mini video switcher!

    https://youtu.be/zl-b7upm2Qg

    0
  • You can also use the Ethernet port on the Boost to use a cat 5 or cat 6 cable directly to a computer. Currently I run 3 Mevos with the Boost Ethernet port using 3 cat 5 cables —> to a standard WiFi/router Ethernet ports —> 1 cat 5 cable to a CPU running Studio 6. With the Mevo cameras wired via Ethernet to a network router, I have a stable, wired way to rig three Mevos up to one computers Ethernet Port.

    0
  • I have this setup above in the picture but wireless. I'm using a Memo camera connected wirelessly to an iPad running Mevo 2.0, then the iPad is connected via HDMI to the ATEM Mini switcher. My question...is there a way to have the Mevo 2.0 software show a clean HDMI video...without the red dot on the left and the menu buttons on the right. Right now if I select the iPad as my HDMI input, it shows all the menus. I'm looking for it to be clean.

    1
  • Hey Kohnen, do you have a solution for that problem? I face the same challenge. Thanks for a feedback.

    0
  • I too would be very much interested in any way someone has figured out the best way to use the MEVO with ATEM Mini switcher and how to get a clean HDMI output from the MEVO.   MEVO Support, can you provide any recommendations on this:?   I cannot imagine you don't get lots of questions about how to connect MEVO to HDMI input devices.  Thanks a zillion !

    0

Article is closed for comments.